Open Access Open Access  Restricted Access Subscription or Fee Access

Prediction of Magnetic Losses in FeSiNO Sheets in Unidirectional Alternating Field and Rotating Field


(*) Corresponding author


Authors' affiliations


DOI: https://doi.org/10.15866/iremos.v9i5.9700

Abstract


This article presents a measurement and a theoretical determination of magnetic losses in the ferromagnetic non oriented iron silicon sheets (FeSiNO), in unidirectional alternating field and rotating field. The theoretical prediction of the magnetic losses is obtained by using three analytical models Model 1 and Model 2 in unidirectional alternating field and Model 3 in rotating field. In order to take into account the harmonics of the magnetic induction waveform, the three models are based on the variation speed of magnetic induction dB/dt that has a direct dependency of the loss due to the domain wall motion. In addition, using physical parameters of the material, the Model 1 allows the separation of magnetic losses. These parameters are determined experimentally in order to take into account the nonlinearity of the material. Analytical magnetic losses obtained with the three models are consistent with experimental magnetic losses. Rotating magnetic losses are approximated by alternating twice the magnetic losses, to the same maximum magnetic induction and to the same frequency.
Copyright © 2016 Praise Worthy Prize - All rights reserved.

Keywords


Ferromagnetic Sheets FeSiNO; Magnetic Losses; Unidirectional Alternating Field; Rotating Field; Variation Speed of Magnetic Induction dB/dt

Full Text:

PDF


References


Samaranayake, L., Chin, Y., Speed Synchronized Control of Permanent Magnet Synchronous Motors with Field-Weakening Capability, (2014) International Review of Aerospace Engineering (IREASE), 7 (3), pp. 108-115.

Ruuskanen, V., Immonen, P., Additional Loss Caused by Drive Cycle Load Transients in Permanent Magnet Traction Motors, (2015) International Review on Modelling and Simulations (IREMOS), 8 (1), pp. 6-10.
http://dx.doi.org/10.15866/iremos.v8i1.4922

Montonen, J., Pyrhönen, J., Performance Analysis of Tooth-Coil Permanent Magnet Traction Motors with Embedded Magnets and Saliency, (2016) International Review of Electrical Engineering (IREE), 11 (1), pp. 9-19.
http://dx.doi.org/10.15866/iree.v11i1.7927

Hidouri, N., An Advanced Direct Torque Control Applied to a Fuzzy Controlled Hybrid Photovoltaic-Diesel Pumping System based on PMS Machines, (2015) International Review of Electrical Engineering (IREE), 10 (3), pp. 352-361.
http://dx.doi.org/10.15866/iree.v10i3.5382

Inayathullaah, M., Anita, R., Experimental Evaluation of Fuzzy logic based Five Phase PMBLDC motor drive, (2014) International Review of Electrical Engineering (IREE), 9 (4), pp. 757-763.
http://dx.doi.org/10.15866/iree.v9i4.2230

Mansouri, A., Msaddek, H., Trabelsi, H., Optimum Design of a Surface Mounted Fractional Slots Permanent Magnet Motor, (2015) International Review of Electrical Engineering (IREE), 10 (1), pp. 28-35.
http://dx.doi.org/10.15866/iree.v10i1.4104

G. Bertotti, "General Properties of Power Losses in Soft Magnetic Materials", Transactions on Magnetics (IEEE), Vol. 24, N°. 1, January 1988, pp. 621-630.
http://dx.doi.org/10.1109/20.43994

G. Bertotti and M. Pasquale,"Physical Interpretation of Induction and Frequency Dependence of Power Losses in Soft Magnetic Materials", Transactions on Magnetics (IEEE), Vol. 28, N°.5, September 1992, pp. 2787-2789.
http://dx.doi.org/10.1109/20.179627

E. Barbisio, F. Fiorillo, and C. Ragusa, Predicting Loss in Magnetic Steels Under Arbitrary Induction Waveform and With Minor Hysteresis Loops, Transactions on Magnetics (IEEE), Vol. 40, N°. 4, July 2004, pp. 1810-1819.
http://dx.doi.org/10.1109/tmag.2004.830510

A. Boglietti, R. Bojoi, A. Cavagnino, M. Lazzari, Core Loss Estimation Method for PWM Inverter Fed Induction Motors , 36 th Annual conference on Industrial Electronics Society (IEEE), November 2010, pp. 811-816.
http://dx.doi.org/10.1109/iecon.2010.5675180

J. Reinert, A.Brockmeyer, and Rik W. A. A. De Doncker, Calculation of Losses in Ferro- and Ferrimagnetic Materials Based on the Modified Steinmetz Equation , Transactions on Industry Applications (IEEE), Vol. 37, N°. 4, Jul/Aug 2001, pp. 1055-1061.
http://dx.doi.org/10.1109/28.936396

L. Mandache and D. Topan, Managing Eddy Current Losses and Ferromagnetic Material Nonlinearities in Distorting Regimes , Electric machines and drives conference (IEEE), May 2009, pp. 1449-1454.
http://dx.doi.org/10.1109/iemdc.2009.5075393

M. S. Lancarotte and A.de A. Penteado, Jr, Estimation of Core Losses under Sinusoidal or Non-Sinusoidal Induction by Analysis of Magnetization Rate, Transactions on Energy Conversion (IEEE), Vol. 16, N°. 2, June 2001, pp. 174-179.
http://dx.doi.org/10.1109/60.921469

M. D. Bui, U. Schaefer, Core Losses Measurement Technique for High Frequency and Flux Density of Switched Reluctance Machines, IEEE Electrical Machines (ICEM), September 2012 , pp. 1619-1624.
http://dx.doi.org/10.1109/icelmach.2012.6350096

D. Eggers, S. Steentjes, and K. Hameyer,Advanced Iron-Loss Estimation for Nonlinear Material Behavior, Transactions on Magnetics (IEEE), Vol. 48, N°. 11, November 2012, pp. 3021-3024.
http://dx.doi.org/10.1109/tmag.2012.2208944

J. Gyselinck and P. Dular, A Time-Domain Homogenization Technique for Laminated Iron Cores in 3-D Finite-Element Models, Transactions on Magnetics (IEEE), Vol. 40, N°. 2, March 2004, pp. 856-859.
http://dx.doi.org/10.1109/tmag.2004.825152

J. G. Zhu, V. S. Ramsden, Improved Formulations for Rotational Core Losses in Rotating Electrical Machines , Transactions on Magnetics (IEEE), Vol. 34, N°. 4, July 1998, pp. 2234-2242.
http://dx.doi.org/10.1109/20.703861

A. Boglietti, A Cavagnino, A.M. Knight, Isolating the impact of PWM modulation on motor iron losses, Industry Applications society (IEEE), October 2008, pp. 1-7.
http://dx.doi.org/10.1109/08ias.2008.50

D. Lin, P. Zhou, W. N. Fu, Z. Badics, and Z. J. Cendes, A Dynamic Core Loss Model for Soft Ferromagnetic and Power Ferrite Materials in Transient Finite Element Analysis , Transactions on Magnetics (IEEE), Vol. 40, N°. 2, March 2004, pp. 1318-1321.
http://dx.doi.org/10.1109/tmag.2004.825025

Bitam-Megherbi, F., Sedkaoui, L., Megherbi, M., Mekious, M., A Specific Magnetic Losses Calculation in Non Oriented Electrical Steel Laminations, (2013) International Journal on Engineering Applications (IREA), 1 (5), pp. 283-287.

J. Mühlethaler, J. W. Kolar, and A. Ecklebe, Loss modeling of inductive components employed in power electronic systems, 8th International Conference on Power Electronics(IEEE),May-June 2011, pp.945-952.
http://dx.doi.org/10.1109/icpe.2011.5944652

Jieli Li, T. Abdallah, C. R. Sullivan, Improved Calculation of Core Loss with Nonsinusoidal Waveforms, Industry Applications Society (IEEE), October 2001, pp. 2203–2210.
http://dx.doi.org/10.1109/ias.2001.955931

A.J. Moses, Importance of rotational losses in rotating machines and transformers, Journal of Materials Engineering and Performance, Vol 1(2), April 1992, pp. 235-244.
http://dx.doi.org/10.1007/bf02648622

N. Stranges, RD. Findlay, Fellow, Importance of rotational iron loss data for accurate prediction of rotating machine core losses, Industry Application Society(IEEE), Vol.1, October 1994, pp. 123-127.
http://dx.doi.org/10.1109/ias.1994.345489

H. Shimoji, M. Enokizono, and T. Todaka, Iron loss and magnetic fields analysis of permanent magnet motors by improved finite element method with E&S model , Transaction on Magnetics (IEEE), Vol. 37, N°. 5, September 2001, pp. 3526-3529.
http://dx.doi.org/10.1109/20.952653

Y. Maeda, H. Shimoji, T. Todaka, M. Enokizono, Rotational power loss of magnetic steel sheets in a circular rotational magnetic field in CCW/CW directions, Journal of Magnetism and Magnetic Materials, April 2008, pp. 567-570.
http://dx.doi.org/10.1016/j.jmmm.2008.04.144

D. Vulkadinovic, M. Smajo, Analysis of magnetic saturation in induction motor drives, (2008) International Review of Electrical Engineering (IREE), 3 (2), pp. 326-336.

N. Fabadi, T. Abbasian, Salmasi, F. Rajaei, A Flux Observer with Online Estimation of Core Loss and Rotor Resistances for Induction Motors, (2009) International Review of Electrical Engineering (IREE), 4 (5), pp. 816-824.

E. E. El-kholy, A. Alwadie, Hossam Youssef, A. A. Abouelfadl, Efficiency Optimized Indirect Field Oriented Control of Induction Motor Impacting Iron Loss, (2012) International Review of Electrical Engineering (IREE), 7 (3), pp. 4419-4427.

D. Yokoyama, T. Sato, T. Todaka, and M. Enokizono, Comparison of iron loss characteristics of divided cores considering vector magnetic properties, Transactions on Magnetics (IEEE), Vol. 50, N°. 4, April 2014.
http://dx.doi.org/10.1109/tmag.2013.2284921

T. Kajiwara, K. Ooka, and M. Enokizono, Development of an electrical steel sheet developed by vector magnetic characteristic control, Electrical Machines (ICEM), September 2014, pp. 1108-1113.
http://dx.doi.org/10.1109/icelmach.2014.6960320


Refbacks

  • There are currently no refbacks.


Please send any question about this web site to info@praiseworthyprize.com
Copyright © 2005-2024 Praise Worthy Prize