Analysis of DC Bus Fault and Line Faults on Voltage Source Inverter Fed Induction Motor

K. Mohanraj; S. Paramasivam; Subhransu Sekhar Dash; S. Ramprasad

doi:10.15866/iremos.v6i6.2681

Analysis of DC Bus Fault and Line Faults on Voltage Source Inverter Fed Induction Motor

K. Mohanraj^(1*), S. Paramasivam⁽²⁾, Subhransu Sekhar Dash⁽³⁾, S. Ramprasad⁽⁴⁾

^(*) Corresponding author

DOI's assignment:
the author of the article can submit here a request for assignment of a DOI number to this resource!
Cost of the service: euros 10,00 (for a DOI)

Abstract

Induction motors are commonly used in industry because of their reliable performance. Most of the induction motors are used in inverter based drives arrangements in industries. Although, Induction motors are highly reliable, they are vulnerable to numerous faults that can result severe damage in terms of production shutdowns, break down of the equipment and hazardous to the users. So it is required to detect faults at its preliminary level to avoid absolute failure of the system and also unpredicted production costs. In this paper, various faults that could occur at the voltage source inverter fed induction motor and their consequences on its performance are analysed.
Copyright © 2013 Praise Worthy Prize - All rights reserved.

Keywords

DC Link; Line to Ground Fault; Induction Motor; Inverter Switch Faults; Total Harmonic Distortion

Full Text:

PDF

References

A. Bellini, F. Filippetti, C. Tassoni, and G.-A. Capolino, “Advances in diagnostic techniques for induction machines,” IEEE Trans. Ind. Electron.,vol. 55, no. 12, pp. 4109–4126, Dec. 2008

B. Akin, U. Orguner, H. A. Toliyat, and M. Rayner, “Phase-sensitive detection of motor fault signatures in the presence of noise,” IEEE Trans. Ind. Electron., vol. 55, no. 6, pp. 2539–2550, Jun. 2008.

S. Khomfoi and L. M. Tolbert, “Fault diagnosis and reconfiguration for multilevel inverter drive using AI-based techniques,” IEEE Trans. Ind. Electron., vol. 54, no. 6, pp. 2954–2968, Dec. 2007.

Charfi, F, Messaoud, M. B., Francois, B., Al-Haddad, K., Sellami, F., Enhanced micro modeling technique for semiconductor devices to study faulty mode in power converters, (2007) International Review of Electrical Engineering (IREE), 2 (3), pp. 327-336.

S. Khomfoi and L. M. Tolbert, “Fault diagnostic system for a multilevel inverter using a neural network,” IEEE Trans. Power Electron., vol. 22, no. 3, pp. 1062–1069, May 2007.

Z. Zidani, D. Diallo, M. E. H. Benbouzid, and R. Nait-Said, “A fuzzybased approach for the diagnosis of fault modes in a voltage-fed PWM inverter induction motor drive,” IEEE Trans. Ind. Electron., vol. 55, no. 2, pp. 586–593, Feb. 2008.

Khlaief, A., Jemli, K., Boussak, M., Gossa, M., Study on inverter's IGBT fault behavior with permanent magnet synchronous motor's drive, (2011) International Review of Electrical Engineering (IREE), 6 (4), pp. 1581-1588.

S. Karimi, A. Gaillard, P. Poure, and S. Saadate, “FPGA-based real-time power converter failure diagnosis for wind energy conversion systems,” IEEE Trans. Ind. Electron., vol. 55, no. 12, pp. 4299–4308, Dec. 2008.

A. K. Wallace and R. Spee, “The simulation of brushless DC drive failures,” in Proc. IEEE PESC, 1988, pp. 199–206.

D. Kastha and B. K. Bose, “Investigation of fault modes of voltage fed inverter system for induction motor drive,” IEEE Trans. Ind. Appl.,vol. 30, no. 4, pp. 1028–1038, Jul./Aug. 1994.

A. Lahyani, P. Venet, G. Grellet, and P. Viverge, "Failure prediction of electrolytic capacitors during operation of a switchmode power supply," Power Electronics, IEEE Transactions on, vol. 13, no. 6, pp. 1199-1207,2002.

Abramik S, W Sleszynski, J Nicrnanski, H Piquet. A diagnostic method fir &-line foul1 detection and localizarion in VSI-FED ac driver. Proceedings of the 10th Europcan Confcrcncc on Powcr Electronicsand Applicatians. Toulousc, France. CD-ROM papcr. 2003

Benbouzid MEH. A loss-minimization DTC scheme for EV induction motors. Proc. IEEE VPPC, Chicago, IL. 2005: 315-321.

Benbouzid MEH, D Diallo, M Zeraoulia. Advanced fault tolerant control of induction-motor drives for EV /HEV traction applications: From conventional to modern and intelligent control techniques. IEEE Trans. Vehicular Technol., 2007; 56.

Gaillard, A., Karimi, S., Poure, P., Saadate, S., Fault tolerant back-to-back converter topology for wind turbine with Doubly Fed Induction Generator, (2007) International Review of Electrical Engineering (IREE), 2 (4), pp. 629-637.

Chan CC. The state of the art of electric and hybrid vehicles. Proc. IEEE. 2002; 90: 247-275. DOI:10.1109/5.989873

Chokhawala RS, J Catt, L Kiraly. A discussion on IGBT short-circuit behavior and fault protection schemes. IEEE Trans. Industry Applications. 1995; 31: 256-263. DOI: 10.1109/28.370271

Eason G, B Noble, IN Sneddon. On certain integrals of Lipschitz-Hankel type involving products of Bessel functions. Phil. Trans. Roy. Soc. London. 1995; A247: 529-551.

Gerada C, M Sumner, J Arellano-Padilla. Investigation of induction machine phase open circuit faults using a simplified equivalent circuit model. Electrical and Electron. Eng., Univ. of Nottingham. 2008.

Mendes AMS, XM Lopez-Fernandez, AJM Cardoso. Thermal behaviour of a three-phase induction motor fed by a fault-tolerant voltage source inverter. IEEE Trans. Industry Applications. 2007; 43: 724-730.

Refbacks

There are currently no refbacks.

Username
Password
Remember me