Modelling of a Working Cycle of an Electro-Hydraulic Forklift in Matlab Simulink


(*) Corresponding author


Authors' affiliations


DOI's assignment:
the author of the article can submit here a request for assignment of a DOI number to this resource!
Cost of the service: euros 10,00 (for a DOI)

Abstract


Evaluation of an electro-hydraulic system of a working machine is carried out by a Matlab Simulink model. Modelling of the total forklift system is presented. Analysis and verification of the Simulink model with practical results are also performed for an axial piston hydraulic machine drive. Practical results are presented to demonstrate the cycle energy efficiency of the proposed electro-hydraulic forklift arrangement with potential energy recovery feature.
Copyright © 2013 Praise Worthy Prize - All rights reserved.

Keywords


Drives; Pumps; Permanent Magnet Machines; Energy Efficiency; Energy Recovery; Model

Full Text:

PDF


References


EPA: Clean Air Nonroad Diesel - Tier 4 Final Rule, [Online], available at: http://www.epa.gov/nonroaddiesel/2004fr.htm, accessed April 2011

Wagner, Tier IV emissions regulations: Knowing the facts. [Online]. Available at: http://www.wagnerequipment.com, accessed December 2011.

X. Liang, On improving energy utilization in hydraulic booms, Ph.D. dissertation, 160 ActaPolytechnicaScandinavica, Tampere University of Technology, Finland, 2002.

M. Ivantysynova, Innovations in pump design-what are future directions. International symposium on fluid power, Toyama, 2008

J. Bernard, S. Delprat, F. N. Büchi, T. M. Guerra, Fuel Cell Hybrid Vehicles: Global Optimization Based on Optimal Control Theory, (2006) International Review of Electrical Engineering (IREE), 1 (3), pp. 352–362.

Bae, C.H., Mok, J.K., Byun, Y.S., Lee, K.-W., Design of a series hybrid propulsion system for a bimodal tram, (2010) International Review of Electrical Engineering (IREE), 5 (3), pp. 1027-1032.

Koveos, Y., Tzes, A., Tsahalis, D., Poppet valve parameter optimization of a high frequency operating pump system, (2010) International Review of Mechanical Engineering (IREME), 4 (1), pp. 71-78.

H. Hänninen, M. Pietola, Analysis on the Adaptability of Two Different Hydraulic Energy Recovery Circuits on Various Machine Types and Work Cycles,ASME/BATH 2013 Symposium on Fluid Power and Motion Control, October 6-9, 2013, Sarasota, Florida.

J. I. Yoon, A. K. Kwan, D. Q. Truong. A Study on An Energy Saving Electro-Hydraulic Excavator. ICROS-SICE International Joint Conference 2009, Fukuoka, Japan, August 18-21, 2009

T. Minav, L. Laurila, J. Pyrhönen and V. Vtorov, Direct pump control effects on the energy efficiency in an electro-hydraulic lifting system, (2011) International Review of Automatic Control (IREACO), 4 (2), pp. 235-242.

E. Imanishi, T Nanjo. Dynamic Simulation of flexible Multibody system with Electric-hydraulic drive system. 1th Joint international conference on Multibody System Dynamics, Lappeenranta, Finland, 2010

P. Immonen, L. Laurila, J. Pyrhönen, Modelling of a Diesel-Electric Parallel Hybrid Drive System in Matlab Simulink, (2009) International Review on Modelling and Simulations (IREMOS), 2 (5), pp. 565-572

L. Chen, F. Zhu, M. Zhang, Y. Huo, C. Yin, H. Peng, Design and Analysis of an Electrical Variable Transmission for a Series-Parallel Hybrid Electric Vehicle, IEEE Transactions on Vehicular Technology, in press, 2011.

Minav, T.A., Filatov, D.M., Laurila, L.I.E., Pyrhonen, J.J., Vtorov, V.B., Modelling of an electro-hydraulic forklift in Matlab Simulink, (2011) International Review on Modelling and Simulations (IREMOS), 4 (2), pp. 640-647.

Minav, T., Electric-drive-based control and electric energy regeneration in a hydraulic system. Doctoral thesis, ActaUniversitatisLappeenrantaensis 436, Lappeenranta University of Technology, Finland, 2011.

Minav T., Laurila L., Immonen P., Pyrhönen J., Vtorov V. and Niemelä M. 2011. Electric energy recovery system for a hydraulic forklift – theoretical and experimental evaluation.IET Electric Power Applications, Vol.5, issue 4, April 2011.

J.Pyrhonen, T. Jokinen, and V. Hrábovcová, Design of rotating electrical machines. (John Wiley & Sons, 2008)

SEW Eurodrive. The DS/CM synchronous servomotors from SEW-Eurodrive. [Online]. available at: http: //www.eurodrive.com, (2006).

H.E. Miller, Hydraulic control systems. (John Wiley & Sons, 1967)

H.Yousefi, H. Handroos, A Soleimani, Application of Differential Evolution in System Identification of a Servo-hydraulic System with a Flexible Load, Mechatronics, Vol. 18, Issue 9, November 2008, pp 513-528

S.R. Majumdar, Oil Hydraulic Systems principles and maintenance. (McGraw-Hill, 2002)

DesignAerospace LLC, [Online]. available at www.daerospace.com, accessed January 2010


Refbacks

  • There are currently no refbacks.


Please send any question about this web site to info@praiseworthyprize.com
Copyright © 2005-2024 Praise Worthy Prize