Analysis of FEA Based Simulation for Torque and Force Calculation of SEIG for Wind Power Application


(*) Corresponding author


Authors' affiliations


DOI's assignment:
the author of the article can submit here a request for assignment of a DOI number to this resource!
Cost of the service: euros 10,00 (for a DOI)

Abstract


This paper presents simulation approach for the performance analysis of self-excited induction generator (SEIG) for wind power application. The analysis like flux distribution, flux density distribution, and torque and force calculations through 2D finite element analysis (FEA). An induction machine model considered as phase voltage, phase angle calculations through ANSYS simulation. At the beginning, a numerical calculation of the magnetic field distribution of self-excited induction machine, under consideration is carried out. The results of numerical calculations are to be presented through ANSYS simulation and an evaluation of the steady state behavior of the self-excited induction generator is presented for the wind power application.
Copyright © 2013 Praise Worthy Prize - All rights reserved.

Keywords


Wind Turbine (WT); Self-Excited Induction Generator (SEIG); Wind Power Generator; Finite Element Analysis (FEA)

Full Text:

PDF


References


Janakiraman.R and Paramasivam.S,” A Novel Method for Modeling, Simulation and Design analysis of SEIM for Wind Power Generation,” 3rd Int. Conf. on Control, Communication and Power Engineering-CCPE 2012, 27th & 28th April 2012, pp.496-502, Springer 2012.

Abbassi, R., Chebbi, S., Energy management strategy for a grid-connected wind-solar hybrid system with battery storage: Policy for optimizing conventional energy generation, (2012) International Review of Electrical Engineering (IREE), 7 (2), pp. 3979-3990.

Janakiraman.R and Paramasivam.S,” Model and Design Analysis of Gearless PM Stator-less Contra-Rotation Wind Power Generator,” International Journal of Engineering Research & Technology (IJERT), Vol.1, No.4, pp. 1-8, June 2012.

Sarajčev, P., Goić, R., An EMTP model for lightning surge analysis of wind farms, (2010) International Review on Modelling and Simulations (IREMOS), 3 (1), pp. 70-81.

Janakiraman.R and Paramasivam.S,” Modeling of Contra-Rotating Permanent Magnet Synchronous Machine for a Wind Power Generation,” IEEE Sponsored International Conf. on Emerging trends in Electrical Engineering and Energy Management (ICETEEEM-2012), AVIT, Chennai, 13-15 December 2012.

Jafar Adabi, Firuz Zare,” Analysis, Calculation and Reduction of Shaft Voltage in Induction Generators,” International Conference on Renewable Energies and Power Quality (ICREPQ’09), Valencia (Spain), 15th to 17th, pp.1-7, April, 2009.

S. Chaves1, J. R. Camacho1, H. de Paula2, M. L. R. Chaves1 and E. Saraiva1,” Induction Motor Capacitances Calculation Using FEA for Common Mode Current Studies in ATP,” International Conference on Renewable Energies and Power Quality (ICREPQ’11), Las Palmas de Gran Canaria (Spain), 13th to 15th April, pp.1-5, 2011.

S. O. Kwon, J. J. Lee, B. H. Lee, J. H. Kim, K.H.Ha and J. P. Hong,” Loss Distribution of Three-Phase Induction Motor and BLDC Motor According to Core Materials and Operating,” IEEE Trans. on Magnetics,” VOL. 45, (Issue. 10, pp.4740-4743, October 2009.

Govindaraj Thangavel, Debashis Chatterjee and Ashoke K. Ganguli,” Design, development and finite element magnetic analysis of an axial flux PMLOM,” International Journal of Engineering and Technology Vol.2, (Issue.2), pp.169-175, 2010.

Aldo Boglietti, Andrea Cavagnino, David Staton,Martin Shanel, Markus Mueller, and Carlos Mejuto,” Evolution and Modern Approaches for Thermal Analysis of Electrical Machines, IEEE Trans.on Industrial electronics, Vol. 56, (Issue.3), pp. 871-882, March 2009.

M.Vasudevan, R.Arumugam and S.Paramasivam,” Real timeimplementation of viable torque and flux controllers and torque ripple minimization algorithm for induction motor drive,” ELSVIER energy Conversion and management, Vol.47, pp.1359-1371, 2006.

Y.Uqtug, M.Demirekier,”Modelling, analysis and ontrol of a wind-turbine driven self-excited induction generator,” IEEE Proc., Vol. 135, Pt. C, (Issue.4), pp.368-375, July1988.

Lihui Yang, Zhao Xu, Jacob Ostergaard, Zhao Yang Dong, Kit Po Wong and Xikui Ma,” Oscillatory Stability and Eig en value Sensitivity Analysis of a DFIG Wind Turbine System,” IEEE Trans. on Energy Convers., pp.1-12, 2011.

G. Quinonez-Varela and A. Cruden,” Modelling and validation of a squirrel cage induction generator wind turbine during connection to the local grid,” IET Gener. Transm. Distrib., 2008, Vol. 2, No.2, pp. 301–309, March, 2008.

A.Kishore, R.C.Prasad, BIT, India,” MATLAB SIMULINK Based DQ Modeling an Dynamic Characteristics of Three Phase Self Excited Induction Generator,” Progress In Electromagnetics Research Symposium 2006, Cambridge, USA, March 26-29, 2006.

Harish Kumar, Neel Kamal,” Steady State Analysis of Self- Excited Induction Generator,” International Journal of Soft Computing and Engineering (IJSCE), Vol.1, (Issue.5), pp.248-253, November, 2011.

K.S. Sandhu and S.P.Jain,”Steady State Operation of Self-Excited Induction Generator with Varying Wind Speeds,” International Journal of Circuits, Systems and Signal Processing, Vol. 2, (Issue.1), pp.26-33, 2008.

Dheeraj Joshi, K S Sandhu,” Excitation Control of Self Excited Induction Generator using Genetic Algorithm and Artificial Neural Network,” International Journal of Mathematical Models in Applied Sciences, Vol. 3, (Issue.1), pp.68-75, 2009.

E. Muljadi and C.P. Butterfield, Sallan and M. Sanz,” Investigation of Self-Excited Induction Generators for Wind Turbine Applications,” IEEE Industry Appl., Society Annual Meeting, October 3-7, 1999.

Mohamed S.EI Moursi, Birgitte Bak-Jensen and Mansour H. Abdel-R ahman,” Coordinated Voltage Control Scheme for SEIG-Based Wind Park Utilizing Substation STATCOM and ULTC Transformer,” IEEE Trans. on Sustainable Energy, Vol.2, (Issue.3), JULY 2011.

K. Satyanarayana, J. Amarnath, A. Kailasa Rao,” Hybrid PWM Algorithm Based Vector Controlled Induction Motor Drive to Achieve Superior Waveform Quality,” International Journal of Engineering and Advanced Technology (IJEAT), Vol.1, (Issue.2), pp.56-63, December 2011.

Jawad Faiz1,Behrooz Rezaeealam, and Sotoshi amada,”Coupled Finite-Element/Boundary-Element Analysis of a Reciprocating Self-Excited Induction Generator in a Harmonic Domain,” IEEE Trans.on Magnetics,Vol.41, (Issue.11), pp.4250-4256, November 2005.

Mahmoudi, A., Kahourzade, S., Rahim, N.A., Hew, W.P., Optimum design of an inside-out axial-flux permanent-magnet motor using genetic algorithm and finite element analysis, (2012) International Review of Electrical Engineering (IREE), 7 (2), pp. 3814-3827.


Refbacks

  • There are currently no refbacks.


Please send any question about this web site to info@praiseworthyprize.com
Copyright © 2005-2024 Praise Worthy Prize