Simulation Studies of Follow Current Struck by 10/350μs Impulse Current

Xiaoming Ren(1*), Zhou Qin(2)

(1) Shanghai DianJi University, China
(2) ShangHai JiaoTong University, China
(*) Corresponding author


DOI's assignment:
the author of the article can submit here a request for assignment of a DOI number to this resource!
Cost of the service: euros 10,00 (for a DOI)

Abstract


The paper introduced the work principle of the 10/350μs impulse current generation and analyzed the feature of the crowbar trigger circuit. Crowbar trigger circuit with 10/350μs impulse current and follow current of voltage switching type surge protective device (SPD) has been researched using EMTP simulation. In order to simulate voltage switching type SPD, the equivalent impedance of the sample and the acting time of crowbar can be obtained from test. The simulation showed that follow current trend of positive and negative polarity were almost the same under impulse of 10/350μs impulse current. With the same synchronous trigger angle, the initial part of follow current of SPD can be influenced due to the different polarity of impulse current.
Copyright © 2013 Praise Worthy Prize - All rights reserved.

Keywords


Impulse Current Generator; Voltage Switch Type Surge SPD; Crowbar Trigger Circuit; Equivalent Impedance; EMTP Simulation

Full Text:

PDF


References


IEC61643-1: Surge protection protective device connected to low-voltage power distribution systems-part1: performance requirements and testing methods, 2010.

Sun Wei, Chen Wenzhen, Determination of impulse current circuit parameters, High Voltage Engineering, n.3, 1990 pp.39– 40.

Liu Liang, Zhang GuiXin, Luo ChengMu, Wang XinXin, An Improved Method to Design Surge Generators, Trancactions of China Electrotechnical Society, vol. 22 n. 5, May 2007,pp.6–

Chen Lidong, Han Min, Lin Yi, The development of 1/ 10μs impulse current generator, High Voltage Engineering, vol. 29 n .9, September 2003, pp. 44–45.

Liu Yang, Wang Jianguo, Zhou Wenjun, Xue Jian, Intelligent impulsive current test system, Electric Power Automation Equipment, vol. 28 n.5, 2008, pp. 103–106

Zhang Renyu, Chen Changyu, High voltage test techniques, Beijing: Tsinghua University Press, 2003

Wen Yuanfang, High Voltage Technology, wuhan: Huazhong University of Science and Technology Press, 2001

Yao Xueling, Chen Jingliang, Sun Wei, Design of a high efficiency 10/ 350μs impulse current generator, High Voltage Engineering, vol. 31 n.5, May 2005, pp.14–16.

Yao Xueling, Chen Jingliang, Sun Wei, “Study on the Impulse Current for Non-linear Resistances,” High Voltage Apparatus, vol. 41 n. 6, December 2005, pp.412–419.

Yuan Haiyan, Wu Jiangqiang, Fu Zhengcai, Chen Jian, Sun Wei, An improved designing method of metal oxide arrester impulse test circuit parameter, Trancactions of China Electrotechnical Society, vol. 26 n.11,2011, pp. 210–216

Arias HJ. A linear relationship between the time constants ratio of an impulse generator and the virtual times ratio of its output waveform, IEEE Transactions Power Delivery, vol.23 n. 2, 2008, pp. 1264–1265

Sheehy R, Yi Li, An impulse voltage calibrator of low output impedance, IEEE Transactions Power Delivery, vol.20 n.1, 2005, pp. 15–22


Refbacks

  • There are currently no refbacks.



Please send any question about this web site to info@praiseworthyprize.com
Copyright © 2005-2021 Praise Worthy Prize