Investigation of Core Thickness Undersized on Composite Panels


(*) Corresponding author


Authors' affiliations


DOI's assignment:
the author of the article can submit here a request for assignment of a DOI number to this resource!
Cost of the service: euros 10,00 (for a DOI)

Abstract


The purpose of this study is to investigate the core thickness undersized problem which is very common with honeycomb core cutting. These defects occur during the honeycomb core cutting by using core block saw machine. There are number of variable causes of the defect. The author is use statistical approach to identify critical variable causing of this defect. There are use two method of the quality tool such as Ishikawa Diagram and also Five Why Method. However the revolutionary read of core thickness undersized is collected to analyze. Minitab software is used for the analysis propose and certain improvement are suggested.The defect is occurred during the during the core block saw cut the core block to be a slicing.
Copyright © 2013 Praise Worthy Prize - All rights reserved.

Keywords


Core Thickness; Composite Panels; Undersized

Full Text:

PDF


References


Masaki Imai, Kaizen: The Key to Japan’s Competitive Success, McGraw Hill International Editions, 1991.

Kaizen Teian 1: Developing Systems for Continuous Improvement through Employee Suggestions.

W Steve Smith, The Quality Revolution: Best Practice from the World’s leading Companies, S Abdul Majeed & Co., 1995.

The certified quality technician handbook By Donald W. Benbow, Ahmad K. Elshennawy, H. Fred Walker.

Kaizen for the shopfloor By Productivity Press. Development Team.

Kaikaku: the power and magic of lean: a study in knowledge transfer By Norman Bodek.

The story of managing projects: an interdisciplinary approach edited by Elias G. Carayannis, Young-Hoon Kwak, Frank T. Anbari.

Process problem solving: a guide for maintenance and operations teams By Bob Sproull, Robert Sproull.

Gibson LJ. Mechanical behavior of the Metallic Foams. Ann Rev Mater , SCI 2000;30:191–227.

M.S Hussin, M.F.M.A Hamzas, Hasnul Hadi, Z.A Zailani, A.B.Sanuddin, Design and Fabrication of a Die for Molding Test Press, (2012) International Review of Mechanical Engineering (IREME), 6 (6), pp. 1257-1261.

M.S Hussin, A. B. Sanuddin, M.F.M.A Hamzas, Z.A Zailani, Hasnul Hadi, Bracket Assembly Tail Failure: Identification Of Causes And Proposal For Design Improvement, (2012) International Review of Mechanical Engineering (IREME), 6 (6), pp. 1245-1252.


Refbacks

  • There are currently no refbacks.


Please send any question about this web site to info@praiseworthyprize.com
Copyright © 2005-2024 Praise Worthy Prize