Email this article 
The Control of an Induction Generator Connected to an Electrical Network by FPGA
(*) Corresponding author
DOI's assignment:
the author of the article can submit here a request for assignment of a DOI number to this resource!
Cost of the service: euros 10,00 (for a DOI)
Abstract
This paper presents the control of induction machine connected to an electrical network via a cascaded two-stage conversion chain. The developed algorithm is successfully implanted on Field Programmable Gate Arrays (FPGA). This FPGA combined with fast digital analog converters provides measure calculation real-time. The experimental results are carried out to confirm the high performance of the proposed control algorithms and the effectiveness use of FPGA in order to control systems
Copyright © 2013 Praise Worthy Prize - All rights reserved.
Keywords
References
B. Bomar, “Implementation of a microprogrammed control in FPGA’s”, IEEE Transactions on Industrial Electronics, vol. 49, no. 2, pp. 415-422, 2002.
I. Takahachi, and T. Nogushi, “A new quick response and high efficiency control strategy of an induction motor”, IEEE Trans. On IA., Vol.28, No. 5, Sept/Oct 1986, pp.820-827.
A. A. Naassani, E. Monmasson, et J. P. Louis, " Synthesis of Direct Torque and Rotor Flux Control Algorithms by Means of Sliding Mode Theory ", IEEE Trans. On Industrial Electronics, Vol.51, No. 3, June 2005.
K. Tazi, E. Monmasson and J.P.Louis, .Description of an entirely reconfigurable architecture dedicated to the current vector control of a set of AC machines. ,IEEE-IECON.99 Conf. Proc, Vol.3, pp. 1415-1420, San Jose, USA, November 1999.
Duprat, J. and Muller, J.M., “The CORDIC Algorithm: New Results for Fast VLSI Implementation,” IEEE Transactions on Computers, Vol. 42, pp. 168-178, 1993.
R. Cardenas, R. Pena, G. Asher, J. Clare, "Control Strategies for Enhanced Power Smoothing in Wind Energy Systems Using a Flywheel Driven by a Vector-Controlled Induction Machine", IEEE Transactions on industrial electronics, vol. 48, n° 3, June 2001, pp. 625-635.
S-J. Huang, T-M. Yang, J-T. Huang “FPGA Realization of Wavelet Transform for Detection of Electric Power System Disturbances” IEEE Transactions on power delivery, Vol.17, No.2, pp.388-394, April 2002.
R. Cardenas, R. Pena, G. Asher, J. Clare, "Control Strategies for Enhanced Power Smoothing in Wind Energy Systems Using a Flywheel Driven by a Vector-Controlled Induction Machine", IEEE Transactions on industrial electronics, vol. 48, n° 3, June 2001, pp. 625-635.
M-P.Kazmierkowski, L.Malesani, .Current Control Techniques for Three-Phase Voltage-Source PWM Converters : A Survey. IEEE Transactions on industrial electronics, Vol. 45, no.5, October 1998
Kavian, Y.S., Nekouei, F., Hardware implementing of hysteresis based 3-phase induction motor control on FPGA, (2012) International Review on Modelling and Simulations (IREMOS), 5 (3), pp. 1224-1230.
Stephen, V., Suresh, P., Implementation of a FPGA based hybrid RF-THI PWM control for an inverter-fed induction motor, (2012) International Review on Modelling and Simulations (IREMOS), 5 (6), pp. 2420-2425.
Babaei, E., Sadjadi, A., Sharifian, M.B.B., A new approach to assess the influence of stray load losses on vector control accuracy in voltage-fed induction motor, (2010) International Review on Modelling and Simulations (IREMOS), 3 (4), pp. 525-532.
Saptono, D., Brost, V., Yang, F., VLIW architecture compilation-simulation and its implementation into FPGA, (2011) International Review on Computers and Software (IRECOS), 6 (4), pp. 555-564.
Sridhar, L., Lakshmi Prabha, V., Wireless-based information security scheme for reconfigurable FPGA IP cores, (2012) International Review on Computers and Software (IRECOS), 7 (5), pp. 2277-2284.
Refbacks
- There are currently no refbacks.
Please send any question about this web site to info@praiseworthyprize.com
Copyright © 2005-2024 Praise Worthy Prize
