Open Access Open Access  Restricted Access Subscription or Fee Access

Thermal Analysis of a Parabolic Trough Collectors with Cylindrical and Fractal Receiver Under Serial-Parallel Configuration


(*) Corresponding author


Authors' affiliations


DOI: https://doi.org/10.15866/irecon.v9i4.19563

Abstract


Solar collectors are one of the higher technologies that involve solar radiation available on surface Earth. However, actually, numerous researches have been developed to improve thermal performance in all system, including surface concentration, receiver, transfer fluid and glass cover. The results of the design, the modeling, and the simulation of a parabolic trough collector and central receiver with three different geometries coupled under serial and parallel configuration are presented in this paper. Different geometries have been proposed in receiver pipe in order to increase transfer surface area and improve thermal efficiency. Each model has been simulated by Computational Fluid Dynamics (CFD) in SolidWorks® software specialized on thermal analysis. As results, the maximum temperature of 86°C has been achieved in this research with two collectors with fractal F1 receiver coupled in parallel configuration. In addition, the lower temperature has been obtained with a single cylindrical collector with a final temperature of 61°C. The principal contribution of this works is the analysis of the best configuration to a solar concentrate system as parabolic trough collector, under a serial or parabolic scheme with the purpose of enhancing the heat transfer on receiver and working fluid. Likewise, a novel design in receiver is proposed based on fractal geometries, which show in the study the best temperature results.
Copyright © 2021 Praise Worthy Prize - All rights reserved.

Keywords


Solar Radiation; Parabolic Collectors; Fractal Receivers; Coupled Collectors; Thermal Heat Collectors

Full Text:

PDF


References


S. Izquierdo, C. Montanes, C. Dopazo, and N. Fueyo, Analysis of CSP plants for the definition of energy policies: The influence on electricity cost of solar multiples, capacity factors and energy storage, Energy Policy, vol. 38, no. 10, pp. 6215-6221, 2010.
https://doi.org/10.1016/j.enpol.2010.06.009

K. Dallmer-Zerbe, M. Bucher, A. Ulbig, and G. Andersson, Assessment of capacity factor and dispatch flexibility of concentrated solar power units, in IEEE Grenoble Conference, 2013, pp. 1-6.
https://doi.org/10.1109/PTC.2013.6652252

P. Denholm and M. Hummon, Simulating the value of concentrating solar power with thermal energy storage in a production cost model, Contract, vol. 715, no. 6, pp. 1-4, 2013.
https://doi.org/10.2172/1059140

S. Madaeni, R. Sioshansi, and P. Denholm, Estimating the capacity value of concentrating solar power plants with thermal energy storage: A case study of the southwestern United States, IEEE Trans. Power Syst., vol. 28, no. 2, pp. 1205-1215, 2013.
https://doi.org/10.1109/TPWRS.2012.2207410

G. He, Q. Chen, C. Kang, and Q. Xia, Optimal offering strategy for concentrating solar power plants in joint energy, reserve and regulation markets, IEEE Trans. Sustain. Energy, vol. 3, no. 3, pp. 1245-1254, 7AD.
https://doi.org/10.1109/TSTE.2016.2533637

R. Sioshansi and P. Denholm, The value of concentrating solar power and thermal energy storage, IEEE Trans. Sustain. Energy, vol. 1, no. 3, pp. 173-183, 2010.
https://doi.org/10.1109/TSTE.2010.2052078

M. Sarafraz, I. Tlili, M. Abdul Baseer, and M. Safaei, Potential of Solar Collectors for Clean Thermal Energy Production in Smart Cities using Nanofluids: Experimental Assessment and Efficiency Improvement, Appl. Sci., vol. 9, no. 9, p. 1877, May 2019.
https://doi.org/10.3390/app9091877

M. Nakhjavani, V. Nikkhah, M. M. Sarafraz, S. Shoja, and M. Sarafraz, Green synthesis of silver nanoparticles using green tea leaves: Experimental study on the morphological, rheological and antibacterial behaviour, Heat Mass Transf., vol. 53, no. 10, pp. 3201-3209, Oct. 2017.
https://doi.org/10.1007/s00231-017-2065-9

M. M. Sarafraz and M. Arjomandi, Thermal performance analysis of a microchannel heat sink cooling with copper oxide-indium (CuO/In) nano-suspensions at high-temperatures, Appl. Therm. Eng., vol. 137, pp. 700-709, Jun. 2018.
https://doi.org/10.1016/j.applthermaleng.2018.04.024

M. M. Sarafraz, V. Nikkhah, M. Nakhjavani, and A. Arya, Thermal performance of a heat sink microchannel working with biologically produced silver-water nanofluid: Experimental assessment, Exp. Therm. Fluid Sci., vol. 91, pp. 509-519, Feb. 2018.
https://doi.org/10.1016/j.expthermflusci.2017.11.007

M. A. Sharafeldin and G. Gróf, Evacuated tube solar collector performance using CeO2/water nanofluid, J. Clean. Prod., vol. 185, pp. 347-356, Jun. 2018.
https://doi.org/10.1016/j.jclepro.2018.03.054

R. Martínez-Cuenca et al., Forced-convective heat-transfer coefficient and pressure drop of water-based nanofluids in a horizontal pipe, Appl. Therm. Eng., vol. 98, pp. 841-849, Apr. 2016.
https://doi.org/10.1016/j.applthermaleng.2015.11.050

R. B. Ganvir, P. V. Walke, and V. M. Kriplani, Heat transfer characteristics in nanofluid-A review, Renew. Sustain. Energy Rev., vol. 75, pp. 451-460, Aug. 2017.
https://doi.org/10.1016/j.rser.2016.11.010

M. Mirzaei, S. M. S. Hosseini, and A. M. Moradi Kashkooli, Assessment of Al2O3 nanoparticles for the optimal operation of the flat plate solar collector, Appl. Therm. Eng., vol. 134, pp. 68-77, Apr. 2018.
https://doi.org/10.1016/j.applthermaleng.2018.01.104

E. Farajzadeh, S. Movahed, and R. Hosseini, Experimental and numerical investigations on the effect of Al2O3/TiO2H2O nanofluids on thermal efficiency of the flat plate solar collector, Renew. Energy, vol. 118, pp. 122-130, Apr. 2018.
https://doi.org/10.1016/j.renene.2017.10.102

R. Mondragón, D. Sánchez, R. Cabello, R. Llopis, and J. E. Juliá, Flat plate solar collector performance using alumina nanofluids: Experimental characterization and efficiency tests, PLoS One, vol. 14, no. 2, p. e0212260, Feb. 2019.
https://doi.org/10.1371/journal.pone.0212260

F. Bazdidi-Tehrani, A. Khabazipur, and S. I. Vasefi, Flow and heat transfer analysis of TiO2/water nanofluid in a ribbed flat-plate solar collector, Renew. Energy, vol. 122, pp. 406-418, Jul. 2018.
https://doi.org/10.1016/j.renene.2018.01.056

A. M. Genc, M. A. Ezan, and A. Turgut, Thermal performance of a nanofluid-based flat plate solar collector: A transient numerical study, Appl. Therm. Eng., vol. 130, pp. 395-407, Feb. 2018.
https://doi.org/10.1016/j.applthermaleng.2017.10.166

Q. Wang et al., Performance evaluation and analyses of novel parabolic trough evacuated collector tubes with spectrum-selective glass envelope, Renew. Energy, vol. 138, pp. 793-804, Aug. 2019.
https://doi.org/10.1016/j.renene.2019.02.025

N. Beemkumar, D. Yuvarajan, A. Karthikeyan, and S. Ganesan, Comparative experimental study on parabolic trough collector integrated with thermal energy storage system by using different reflective materials, J. Therm. Anal. Calorim., vol. 137, no. 3, pp. 941-948, Aug. 2019.
https://doi.org/10.1007/s10973-018-07989-6

R. K. M. Aldulaimi, An Innovative Receiver Design for a Parabolic Trough Solar Collector Using Overlapped and Reverse Flow: An Experimental Study, Arab. J. Sci. Eng., vol. 44, no. 9, pp. 7529-7539, Sep. 2019.
https://doi.org/10.1007/s13369-019-03832-8

E. C. Okonkwo, M. Abid, and T. A. H. Ratlamwala, Comparative Study of Heat Transfer Enhancement in Parabolic Trough Collector Based on Modified Absorber Geometry, J. Energy Eng., vol. 145, no. 3, p. 04019007, Jun. 2019.
https://doi.org/10.1061/(ASCE)EY.1943-7897.0000602

E. Bellos, C. Tzivanidis, and D. Tsimpoukis, Multi-criteria evaluation of parabolic trough collector with internally finned absorbers, Appl. Energy, vol. 205, pp. 540-561, Nov. 2017.
https://doi.org/10.1016/j.apenergy.2017.07.141

L. Z. Zhang, Heat and mass transfer in a randomly packed hollow fiber membrane module: a fractal model approach, Int. J. Heat Mass Transf., vol. 54, pp. 13-14, 2011.
https://doi.org/10.1016/j.ijheatmasstransfer.2011.03.005

V. Titov and R. Stepanov, Heat transfer in an infinite layer with fractal distribution of heating elements, IOP Conf. Ser. Mater. Sci. Eng., vol. 208, p. 012039, Jun. 2017.
https://doi.org/10.1088/1757-899X/208/1/012039

G. Pia and U. Sanna, Intermingled fractal units model and electrical equivalence fractal approach for prediction of thermal conductivity of porous materials, Appl. Therm. Eng., vol. 61, no. 2, pp. 186-192, 2013.
https://doi.org/10.1016/j.applthermaleng.2013.07.031

T. Li, R. Wang, J. Kiplagat, and Y. Kang, Performance analysis of an integrated energy storage and energy upgrade thermochemical solid-gas sorption system for seasonal storage of solar thermal, Energy, vol. 50, pp. 454-467, 2013.
https://doi.org/10.1016/j.energy.2012.11.043

X. Meng, X. Xia, C. Sun, and X. Hou, Adjustment, error analysis and modular strategy for Space Solar Power Station, Energy Convers. Manag., vol. 85, pp. 292-301, 2014.
https://doi.org/10.1016/j.enconman.2014.05.070

W. Fuqiang, C. Ziming, T. Jianyu, Y. Yuan, S. Yong, and L. Linhua, Progress in concentrated solar power technology with parabolic trough collector system: a comprehensive review, Renew. Sustain. Energy Rev., vol. 79, pp. 1314-1328, 2017.
https://doi.org/10.1016/j.rser.2017.05.174


Refbacks

  • There are currently no refbacks.


Please send any question about this web site to info@praiseworthyprize.com
Copyright © 2005-2024 Praise Worthy Prize