Novel Removal of Meropenem by Using Permeable Reactive Barrier of Cement Kiln Dust with Filter Sand for Simulated Groundwater Treatment: Batch and Continuous Experiments
(*) Corresponding author
DOI: https://doi.org/10.15866/irece.v11i4.18607
Abstract
The negative consequences of unintentional antibiotic exposure to humans and the ecosystem have raised wide concerns due to their presence in groundwater in large quantities. Recent research has focused on finding low-cost materials for the remediation of groundwater by removing unwanted antibiotics. In this study, Cement Kiln Dust (CKD), currently seen only as a waste by-product of the cement industry and environmental pollutant, has been tested for its potential in removing contaminants from water by way of PRB filtering. The results have been calculated using the Langmuir model, and have showed that at pH 7.0, 60 mg/g was the maximum adsorption capacity. CKD dosage and pH have affected the adsorption process significantly. The performance of PRB has been also affected by initial concentration, influent, and flow rate. The data have been also modelled using COMSOL Multiphysics 3.5a. This model has been integrated with the advection dispersion equation through the Langmuir isotherm. The integrated model has been found to be an effective and efficient tool for describing the migration of contaminants spatially and temporally in the experimental set-up, a one-dimensional packed column. A good agreement has been recognized between the predicted and the measured results of R2 ≥ 0.989 for the breakthrough curves. Finally, the predicted and the experimental results indicate that there is a high affinity of binding sites on CKD for meropenem.
Copyright © 2020 Praise Worthy Prize - All rights reserved.
Keywords
Full Text:
PDFReferences
Z. Abd Ali, L. Naji, S. Almuktar, A. Faisal, S. Abed, M. Scholz, M. Naushad, T. Ahamad. Predominant Mechanisms for the Removal of Nickel Metal Ion from Aqueous Solution Using Cement Kiln Dust. J. Water Process Eng., Vol. 33:101033, 2020.
https://doi.org/10.1016/j.jwpe.2019.101033
I. Ahmed, and M. Gasser, Adsorption Study of Anionic Reactive Dye from Aqueous Solution to Mg–Fe–CO3 Layered Double Hydroxide (LDH), Appl. Surf. Sci., Vol. 259:650-656, 2012.
https://doi.org/10.1016/j.apsusc.2012.07.092
A. Faisal, and L. Naji, Simulation of Ammonia Nitrogen Removal from Simulated Wastewater by Sorption onto Waste Foundry Sand Using Artificial Neural Network, Assoc. Arab Univ. J. Eng. Sci., Vol. 26:28-34, 2019.
https://doi.org/10.33261/jaaru.2019.26.1.004
R. Han, L. Zou, X. Zhao, Y. Xu, F. Xu, Y. Li, Y. Wang, Characterization and Properties of Iron Oxide-Coated Zeolite as Adsorbent for Removal of Copper (II) from Solution in Fixed Bed Column, Chem. Eng. J., Vol. 149:123-131, 2009.
https://doi.org/10.1016/j.cej.2008.10.015
L. Naji, S. Jassam, M. Yaseen, A. Faisal, N. Al-Ansari, Modification of Langmuir Model for Simulating Initial pH and Temperature Effects on Sorption Process, Sep. Sci. Technol.,2019.
https://doi.org/10.1080/01496395.2019.1655055
N. Saad, Z. Abd Ali, L. Naji, A. Faisal, Development of Bi-Langmuir Model for Description Initial pH and Temperature Effects on the Sorption of Cadmium onto Waste Foundry Sand, Environ. Eng. Res., 2019.
https://doi.org/10.4491/eer.2019.277
Akchurin, T., Stefanenko, I., Pushkarskaya, O., Slag Wastes from Regional Metallurgical Industry Used in Construction Compositions, (2017) International Review of Civil Engineering (IRECE), 8 (5), pp. 197-202.
https://doi.org/10.15866/irece.v8i5.12681
T. Shibayama, D. Sugiyama, E. Kamiyama, T. Tokui, T. Hirota, T. Ikeda, Characterization of CS-023 (RO4908463), a Novel Parenteral Carbapenem Antibiotic, and Meropenem as Substrates of Human Renal Transporters, Drug Metab. Pharmacokinet, Vol. 22:41-47, 2007.
https://doi.org/10.2133/dmpk.22.41
M. M-Ridha, and M. A-Ahad, Adsorption of Levofloxacine Antibacterial from Contaminated Water by Non – Conventional Low-Cost Natural Waste Materials, Journal of Engineering, Vol. 20 (Issue 12):88-104, 2014.
Formisano, A., Galzerano, B., Durante, M., Marino, O., Liguori, B., Mechanical Response of Short Fiber Reinforced Fly Ash Based Geopolymer Composites, (2018) International Review of Mechanical Engineering (IREME), 12 (6), pp. 485-491.
https://doi.org/10.15866/ireme.v12i6.14826
M. Turk Sekulic, N. Boskovic, A. Slavkovic, J. Garunovic, S. Kolakovic, S. Pap, Surface functionalised adsorbent for emerging pharmaceutical removal: Adsorption performance and mechanisms. Process Saf. Environ. Prot., Vol. 125:50-63, 2019.
https://doi.org/10.1016/j.psep.2019.03.007
J. Wang, and S. Wang, Removal of pharmaceuticals and personal care products (PPCPs) from wastewater: A review. J. Environ. Manage. Vol. 182:620-640, 2016.
https://doi.org/10.1016/j.jenvman.2016.07.049
M. Wang, G. Li, L. Huang, J. Xue, Q. Liu, N. Bao, J. Huang, Study of ciprofloxacin adsorption and regeneration of activated carbon prepared from Enteromorpha prolifera impregnated with H3PO4 and sodium benzenesulfonate. Ecotoxicol. Environ. Saf., Vol. 139: 36-42, 2017.
https://doi.org/10.1016/j.ecoenv.2017.01.006
Miloudi, M., Merbouh, M., Glaoui, B., Mechanical Properties of Concrete Using Coal Waste (Heap) as Partial Replacements of Fine Aggregate in Hot Weather, (2017) International Review of Civil Engineering (IRECE), 8 (4), pp. 120-124.
https://doi.org/10.15866/irece.v8i4.12273
Y. Wang, C. Shen, M. Zhang, B. Zhang, Y. Yu, The electrochemical degradation of ciprofloxacin using a SnO2-Sb/Ti anode: Influencing factors, reaction pathways and energy demand. Chem. Eng. J., 296:79-89, 2016.
https://doi.org/10.1016/j.cej.2016.03.093
P. Zhao, F. Yu, R. Wang, Y. Ma, Y. Wu, Sodium alginate/graphene oxide hydrogel beads as permeable reactive barrier material for the remediation of ciprofloxacin-contaminated groundwater, Chemosphere, Vol. 200:612-620, 2018.
https://doi.org/10.1016/j.chemosphere.2018.02.157
W. Alnahhal, R. Taha, H. Al-Nasseri, and S. Nishad, Effect of using Cement Kiln Dust as a nanomaterial on the strength of cement mortars, Journal of Civil Engineering, Vol. 24(4):1361-1368, April 2018.
https://doi.org/10.1007/s12205-017-0010-6
O. Zehrudin, N. Haračić, and J. Zelić, Properties of blast furnace cements (CEM III/A, B, C) based on Portland cement clinker, blast furnace slag and cement kiln dusts, Cement and Concrete Composites, Vol. 91:189-197, May 2018.
https://doi.org/10.1016/j.cemconcomp.2018.05.006
H. A. Abdel-Gawwad, K.A. Khalil, Application of thermal treatment on cement kiln dust and feldspar to create one-part geopolymer cement, Construction and Building Materials, Vol.187: 231-237, October 2018.
https://doi.org/10.1016/j.conbuildmat.2018.07.161
H. A. Abdel-Gawwad, K. A. and Khalil, Application of thermal treatment on cement kiln dust and feldspar to create one-part geopolymer cement, Construction and Building Materials, Vol.187: 231-237, October 2018.
https://doi.org/10.1016/j.conbuildmat.2018.07.161
H. A. Abdel-Gawwad, K. A. and Khalil, Application of thermal treatment on cement kiln dust and feldspar to create one-part geopolymer cement, Construction and Building Materials, Vol.187: 231-237, October 2018.
https://doi.org/10.1016/j.conbuildmat.2018.07.161
M. Teixidó, J. Pignatello, J. Beltrán, M. Granados, J. Peccia, Speciation of the Ionizable Antibiotic Sulfamethazine on Black Carbon (Biochar), Environ. Sci. Technol., Vol. 45:10020-10027, 2011.
https://doi.org/10.1021/es202487h
A. Sarmah, M. Meyer, A. Boxall, A Global Perspective on the use, Sales, Exposure Pathways, Occurrence, Fate and Effects of Veterinary Antibiotics (VAs) in the Environment, Chemosphere, Vol. 65:725-759, 2006.
https://doi.org/10.1016/j.chemosphere.2006.03.026
A. Taha, A. Dakroury, G. El-Sayed, S. El-Salam, Assessment Removal of Heavy Metals Ions from Wastewater by Cement Kiln Dust (CKD), J. Am. Sci., Vol. 6:910-917, 2010.
Refbacks
- There are currently no refbacks.
Please send any question about this web site to info@praiseworthyprize.com
Copyright © 2005-2024 Praise Worthy Prize