Browse Title Index


 
Issue Title
 
Vol 3, No 1 (2015) PCA and PLS Study of AIBIIIC2VI and AIIBIVC2V Ternary Chalcopyrite Semiconductors Abstract
A. M. Ferouani, M. R. Merad Boudia
 
Vol 3, No 3 (2015) Performance Assessment of New Brake Actuator with Magneto–Rheological Working Fluid Abstract
Z. Kesy, A. Kesy
 
Vol 3, No 4 (2015) Prediction and Measurement of the Damping Properties of Carbon-Fibre Reinforced Plastics Rectangular Plates Abstract
L. Kherredine, A. Amirat, N. Zeghib
 
Vol 2, No 5 (2014) Prediction of Intralaminar Fracture Toughness of Two Directional Glass Fibre Reinforced Polyester Laminated Composite Plate Abstract
M. Rokbi, A. Imad, H. Osmani, N. Benseddiq
 
Vol 1, No 3 (2013) Preparation and Characterization of Nickel Nanoparticles and Nanowires in Aqueous Solution Under Wet Chemical Process Abstract
K. Alexandrova, I. Dragieva, I. Markova-Deneva, K. J. Klabunde
 
Vol 1, No 6 (2013) Properties of Silica Sand-Based Castings Prepared with Different Proportions of Steel Industry Fly Ash Abstract
P. Karunakaran, C. Jegadheesan, C. Rangasami, P. Sengottuvel
 
Vol 1, No 2 (2013) Recent Development of Novel Lead-Free Composite Solders Using Microwave-Assisted Sintering Powder Metallurgy Route Abstract
M. A. A. Mohd Salleh, A. M. Mustafa Al Bakri, Flora Somidin, H. Kamarudin
 
Vol 3, No 4 (2015) Reducing the Short-Term Aging of Asphalt with Hydrated Lime Abstract
B. Ali, F. H. Chehade, M. Sadek
 
Vol 2, No 2 (2014) Research Note on Surface Tension Relaxation of Lubricants by Humidification of the Gas Phase Abstract
M. A. Alvarez-Valenzuela, S. Jimenez-Lopez, E. Diez-Jimenez, I. Valiente-Blanco, J. L. Perez-Diaz
 
Vol 1, No 5 (2013) Review of Material Used in Brake Pads Abstract
C. M. Ruzaidi, H. Kamarudin, J. B. Shamsul, A. M. Mustafa Al Bakri, W. I. Wan Mastura
 
Vol 1, No 1 (2013) Simulations of Surface Roughness of Nanocomposite Materials by Using Level Set Method Abstract
B. Radjenović, M. Radmilović-Radjenović
 
Vol 1, No 6 (2013) Smart Materials: Overview and a Proposal for Architecture and Construction Abstract
A. Larena, R. Rodriguez-Vera
 
Vol 3, No 4 (2015) Statistical Analysis of Temperature Effect on Fatigue Lifetime of Thin Welded Stainless Steel Sheets Abstract
A. Merabtine, K. Chaoui, Z. Azari
 
Vol 1, No 3 (2013) Studies on Halide-Induced Corrosion on Different Types of Steel Abstract
G. Bassioni
 
Vol 3, No 2 (2015) Study of SnO2 Thin Film Deposited on Soda-lime Glass Using the Spray Pyrolysis Coating Method Abstract
T. Mahdaoui, N. Bouaouadja, M. Hamidouche, J. Simons, F. Petit
 
Vol 3, No 2 (2015) Study of the Effects of Sand Blasting on Soda Lime Glass Erosion Abstract
T. Mahdaoui, N. Bouaouadja, M. A. Madjoubi, C. Bousbaa
 
Vol 1, No 4 (2013) Surface Effect on Ions Distributions in Nanoporous Media, a Molecular Dynamics Study Abstract
Jalal Dweik, Mahmoud Srour, Mohamad Tawbe, Khalil Abou-Saleh
 
Vol 2, No 1 (2014) Synthesis of Proton Exchange Membranes from Natural Rubber Abstract
Alvaro Realpe, Karen Barrios, María T. Acevedo
 
Vol 2, No 1 (2014) Synthesis of Proton Exchange Membranes from Vinyl Acetate and Acrylic Ester for Fuel Cell Abstract
Alvaro Realpe, Nayilis Mendez, María T. Acevedo
 
Vol 2, No 3 (2014) TEM Investigation of Amorphization Kinetics Due to Argon Implantatin in GaAs Abstract
K. Akmoum, M. Mimi
 
Vol 1, No 1 (2013) Temperature Variation Effects on BSIM4 Characteristics in 50nm CMOS Technology Abstract
A. Guen, B. Bouazza, H. Guen, A. Hamdoune, Ne Chabane Sari
 
Vol 1, No 3 (2013) The Effect of Composition and Temperature on the Rheological Properties of Greases Based on Calcium Soaps Abstract
Ancaelena Eliza Sterpu, Nicoleta Teodorescu, Iuliana Marlena Prodea, Anişoara Neagu, Anca Iuliana Dumitru
 
Vol 2, No 4 (2014) The Effect of Microstructure Size on Bar Cross-Sectional Area Changes in Elastic Tensile Deformation Abstract
Olufemi T. Akintayo
 
Vol 1, No 4 (2013) The Effect of Sintering Temperature on Mechanical Properties of Al/SiC Composites Abstract
A. B. Sanuddin, H. Azmi, M. S. Hussin, K. L. Chuan, Z. A. Zailani, M. F. M. A. Hamzas
 
Vol 1, No 4 (2013) The Relationship of Na2SiO3/NaOH Ratio, Kaolin/Alkaline Activator Ratio and Sand/Kaolin Ratio to the Strength of Kaolin-Based Non Load Bearing Geopolymer Brick Abstract
M. T. Muhammad Faheem, A. M. Mustafa Al Bakri, H. Kamarudin, C. M. Ruzaidi, M. Binhussain, A. M. Izzat
 
51 - 75 of 80 Items << < 1 2 3 4 > >> 



Please send any question about this web site to info@praiseworthyprize.com
Copyright © 2005-2022 Praise Worthy Prize