Open Access Open Access  Restricted Access Subscription or Fee Access

Centrifuges for Variable Accelerations Generation


(*) Corresponding author


Authors' affiliations


DOI: https://doi.org/10.15866/ireme.v11i5.11577

Abstract


In order to ensure the reliability of the navigation equipment installed on flying vehicles, it is first tested. To reduce the time of testing and to make it cheaper, tests are run on laboratory equipment on land. The most common type of test equipment with a wide range of capabilities is considered to be the equipment which simulates centripetal acceleration – centrifuges. If centrifuges are used as a basis for combined impacts, complex imitational laws can be simulated, which copy the natural loading conditions more fully. This paper sees into the capabilities for simulation of the parameters of flying vehicles implemented by combined centrifugal stands of various schemes and proposes solutions to some complex technical problems.
Copyright © 2017 Praise Worthy Prize - All rights reserved.

Keywords


Centrifuge; Centrifugal Stand; Double Centrifuge; Rate of Acceleration; Variable Radius Centrifuge; Vibrafuge

Full Text:

PDF


References


Evgrafov A.N, Karazin V.I., Smirnov G.A. Rotary stands for motion variables simulation. Scientific and technical reports of SPbGTU. St.-Petersburg. 1999, N 3(17), pp. 89–94. (in Russian)

Evgrafov A.N., Karazin V.I., Khlebosolov I.O. Playing motion parameters on rotary stands. Theory of mechanisms and machines. 2003, Vol. 1, N 1, pp. 92-96. (in Russian)

Ksenofontov V.I., Nikolaev V.N., Chernokrylov S.Yu. Multifunctional dynamic stand. Testing and control stands. Leningrad, LGTU. 1992. pp. 29 – 32. (in Russian)

Rodgers J. D., Cericola F., Doggett J. W., Young M. L. Vibrafuge: Combined Vibration and Centrifuge Testing. Shok and Vibration Symposium. SAND89 – 1659C. 1989.
http://dx.doi.org/10.4271/892368

Doggett, J. and Cericola, F., "Vibrafuge - A Combined Environment Testing Facility Vibration Testing on a Centrifuge" SAE Technical Paper 892368, 1989.
http://dx.doi.org/10.4271/892368

Doug VanGoethem, Richard Jepsen, and Edward Romero. "Vibrafuge: Re-Entry and Launch Test Simulation in a Combined Linear Acceleration and Vibration Environment", 44th AIAA Aerospace Sciences Meeting and Exhibit, Aerospace Sciences Meetings. 2006.
http://dx.doi.org/10.2514/6.2006-1318

J. Kang, F. Arute, D. Yoel, J. Littlefield, T. Harris. Testing using Combined Environments to Reduce Payload Mass, Cost and Mission Risk. 27 Annual AIAA/USU Conferense on Small Satellites, 2013.
http://dx.doi.org/10.2514/1.a32646

Jepsen, Richard Alan, and Edward F. Romero. Testing in a Combined Vibration and Acceleration Environment. IMAC XXIII, Orlando, FL (2005).
http://dx.doi.org/10.2514/6.2006-1318

Rojers, J. D. Testing in combined dynamic environments. Journal of the IES36.6 (1993): pp.19-25.
http://dx.doi.org/10.1002/9780470035146.ch2

Karazin V.I., Kozlikin D.P., Sloushch A.V., Khlebosolov I.O. Dynamic model of vibratory stand. Theory of mechanisms and machines. № 1 (9), Vol. 5, 2007, pp. 38-44. (in Russian)

Karazin V.I., Kozlikin D.P., Khlebosolov I.O. Dynamic stands for vibro-rotary tests. Scientific and technical reports of SPbGPU. St.-Petersburg; №3(45). 2006. pp. 44-49. (in Russian)

Karazin V.I., Kozlikin D.P., Khlebosolov I.O. On balancing the inertial forces in vibrotsentrifugal. Theory of mechanisms and machines. № 2 (10), Vol. 5, 2007, pp. 63-71. (in Russian)

Karazin V.I., Kozlikin D.P., Sukhanov А.A., Khlebosolov I.O. One Stable Scheme of Centrifugal Forces Dynamic Balance. Advances in Mechanical Engineering, Lecture Notes in Mechanical Engineering. Evgrafov A., (ed.). Springer International Publishing Switzerland, 2016, pp.75-87.
http://dx.doi.org/10.1007/978-3-319-29579-4_8

Panovko Ya.G. Introduction to mechanical vibrations. Moscow: Science, 1980, 272 p. (in Russian)


Refbacks

  • There are currently no refbacks.


Please send any question about this web site to info@praiseworthyprize.com
Copyright © 2005-2024 Praise Worthy Prize